Lot 411: 2015 Hyster H50CT 5,000 lb LPG Forklift, 402 Hours, Sideshift

Auction

Estate & Equipment Auction — Forklifts, Tractor, Mercedes-Benz, Lladro

Lot Number

411

Status

Sold

Hammer / Price

Sign in to view realized price

Opening Bid

$5.00

Accepted Bids

63

Closed

5/17/26 7:08 PM PT

Description

2015 Hyster H50CT 5,000-lb capacity LPG forklift on solid-pneumatic tires, with integral sideshifter and a Mazda four-cylinder LPG drivetrain. Hour meter reads 402 actual hours — placing this unit at the top of the H50CT used-market pool. From a single-owner regional service-fleet consignor in Rocklin, California. Seller Disclosures & Preview Per the seller, the unit runs, drives, and lifts under all hydraulic functions and has been kept in active fleet service. Indicated hours are 402 — an average of roughly 36 hours per year across the truck's 11-year life, consistent with backup or low-utilization fleet duty. Sold as-is from working consignor inventory. Preview by appointment at the warehouse, 3900 Atherton Road, Suite 100, Rocklin CA 95765 , prior to auction close. Description The Hyster H50CT was produced from roughly 2010 to 2018 as the commercial-tier 5,000-lb truck in Hyster's lineup — a cost-conscious companion to the heavier-duty Fortis FT family, aimed at light-to-moderate-duty applications where the buyer values the Hyster service network and the Mazda LPG drivetrain over the stout hydraulic and electrical packaging of the Fortis line. The CT designation is the solid-pneumatic / IC pneumatic-chassis variant (the cushion-tire indoor sibling is the S50CT). Power comes from a Mazda industrial four-cylinder LPG engine driving an electronic powershift transmission with single-speed forward and reverse, controlled from a column-mounted F/N/R lever. Rated capacity is 5,000 lb at a 24-inch load center. The truck wears an integral sideshifter on the carriage, a factory overhead guard with rear taillights and work lamps, hydrostatic steering with steering knob, and a standard accelerator/brake foot-pedal layout. At 402 hours indicated, this unit is well below the 5,000–8,000-hour band that defines the average used H50CT and well clear of the ~10,000-hour rebuild window for the Mazda LPG platform. Specifications Make Hyster Model H50CT Model Year 2015 Serial Number A274V03974N Indicated Hours 402 Rated Capacity 5,000 lb @ 24-inch load center Engine Mazda industrial four-cylinder LPG Fuel LPG (propane); fuel tank included Transmission Electronic powershift, 1 forward / 1 reverse Direction Control Column-mounted F/N/R lever Mast Two-stage upright (per inspection) Sideshift Integral sideshifter on the carriage Tires Solid pneumatic, all four positions Operator Station Open with factory overhead guard, rear taillights, work lamps Steering Hydrostatic, with steering knob Production Years ~2010–2018 Country of Manufacture United States (Hyster, Berea, KY) Cosmetic Condition Cosmetic condition is good for an 11-year-old industrial truck. Yellow paint shows light scuffing on the counterweight corners and cab uprights from typical operator wear. The seat cushion and backrest are intact with surface scuffs and no visible tears. Forks, mast channels, lift chains, and hydraulic hose runs appear clean and free of impact damage. Tires retain even tread across all four corners with no chunking or flat spots visible. The HYSTER decal on the outer mast frame is bright and uncracked. Refer to all photographs for a complete cosmetic assessment. Pickup & Location Located in Rocklin, California — 3900 Atherton Road, Suite 100, Rocklin, CA 95765 Pickup This is a heavy industrial unit — buyer is responsible for pickup, loading, and transport. A flatbed or trailer with adequate load rating and a forklift/loader to load is required. Preview Available by appointment at the warehouse address above, prior to auction close.